sgtstein
29.05.2021 14:27:10
• Engine manufacturer recommends greasing the propeller shaft every 12 months. here
See full version: Mercruiser Alpha I (15 Spline), MPI 260hp Propellers
• Engine manufacturer recommends greasing the propeller shaft every 12 months. here
• Wide open throttle RPM, with boat on the water in forward gear under normal loading conditions, should fall within the range that is recommended by the engine manufacturer and not exceed the recommended maximum. This is important in determining a suitable propeller pitch. When in doubt, dealer assistance is suggested. [links]
• Make sure all propeller hardware is installed correctly. here
• Prop installation, inspection and boat operation all need to be done in a safe and responsible manner. [links]
• It is very important to refer to your engine's Owners Manual for important safety precautions when installing a propeller. more
Another way to prevent getting this page in the future is to use Privacy Pass. You may need to download version 2.0 now from the Chrome Web Store.
If you are on a personal connection, like at home, you can run an anti-virus scan on your device to make sure it is not infected with malware. more
If you are at an office or shared network, you can ask the network administrator to run a scan across the network looking for misconfigured or infected devices. [links]
Completing the CAPTCHA proves you are a human and gives you temporary access to the web property.
Cloudflare Ray ID: 68788195bff190b1 • Your IP : 46.32.66.208 • Performance & security by Cloudflare [links]
Can you get the boat to a competent mechanic? If so, make an offer on the boat contingent upon a successful mechanical inspection. preferably on the water. Best case is you spend a hundred bucks (or so), the mechanic checks everything out and explains to you the operation, care and feeding of your new boat. Worst case is you spend a few bucks and avoid a money pit.
Is the bilge clean? A clean bilge is a good sign that the boat is well cared for.
Re: Common 5.0 L MerCruiser? Alpha I Problem?
So, just wondering if there is any common issue I should be look out for?
I did noticed a very small puddle of water in the bilge area under the engine. Not sure how the water got there. The water looks clean and does appears to be mixed with oil. Should I be concern? more
Re: Common 5.0 L MerCruiser? Alpha I Problem? here
These spacers were developed to allow additional throttle linkage arm clearance for use with many aftermarket EFI Throttle bodies. The small spacer is standard equipment on Hardin marine 4150 series flame arrestors. more
Billet Aluminum Flame Arrestor Spacer
Holley 4500 (7.25" I.D. x 1" Tall) here
These spacers were developed to allow additional throttle linkage arm clearance for use with many aftermarket EFI Throttle bodies.