[dorothymedney]

Michigan Match 3 Blade Aluminum Propeller fits 50-140 HP Suzuki Two & Four Stroke Outboards.4.

[BitSports]

Quicksilver Nemesis-4 Aluminum Propeller Fits 150-300 HP Suzuki Outboard Motors.The Nemesis features.. [links]

[JohanMeert]

Solas Amita 3 Rubex Aluminum Propeller Fits 150-300 Suzuki Outboards.Interchangeable Hub SystemThru-.. [links]

[hypertux]

Im replacing my four anodes on my 2007 df115. My question is that when looking them up on brownspoint there are zinc, aluminum and magnesium types. The boat is used 85% in fresh water and the other in salt. Thanks for any help fellas.

[antimatter15]

the service manual for my '06 175 calls for zinc [links]

[truzza]

also besides the zincs on the outside that you can see,, on my 175 there are a number of ones around the electronics that have a cap .. for lack of better descripition looks like a bubble cap. that should be inspected and replaced as needed.
art [links]

[BlueAchenar]

55125-87D00 Suzuki Outboard Trim Tab Anode.150-225 HP 1986-2003All our Zincs Anodes meet the standar.. more

[AT-LOW]

Solas Amita 3 Plus Aluminum Propeller fits 50-140 HP Suzuki Outboards. (Larger Diameter,Heavier Boat..

[The Eternal Coin]

55320-95310 Suzuki Outboard Small Block Zinc Anode.Fits most models thru 9.9 Thru 200 HP.All our Zin.. more

[emmamarko112]

Quicksilver Black Diamond Aluminum Propeller fits 50-140 HP Suzuki Outboards.The Quicksilver Black D.. [links]

[megas]

So you’ve got to look for these. You’ve got to change them and check them annually. more

[bitcoin_pl]

Here’s what I do. You’ll notice it is threaded inside. The screw bits into the housing, but not into the cover. Those threads allow the threads in the retaining screw to pass through. By using a bolt with bigger threads, and thread it into the cap, I can easily get the zinc off.

[jayrod]

Taking apart the shroud and callies that cover the mid-section of the pan. What we are looking at here is to change the zincs. Alright, the engine has zincs in the cylinder banks. The land and sea four strokes have zincs that you can’t see unless you take the shroud and callies off. See this one here. On the oil pan, the cover hides the zinc. more

[S3052]

Now, one of the things you want to do is to pull a screw (Cylinder). At least you’d think. Once the screw’s off, calcium build up can be seen. See I can barely move it. I might be able to grab it, pry it off, is a temptation, then I would be scratching the protective coating the factory applied. [links]