See full version: Complete DIY Boat Maintenance Guide For Beginners
Check the bilge pump: The bilge pump is an essential part of your boat, it removes water that builds up within the bilge. Without it, your boat could fill up with water and sink. Checking to make sure this is working correctly is a vital part of basic maintenance checks. more
Important: Do NOT walk away from your motor while it is running. As the engine runs, it will create vibrations that will slowly wiggle the Five Oceans Universal Outboard Motor Flusher away from the holes. When this happens, simply reposition them over the holes and let it continue flushing.
Flushing an outboard motor without an easy hose adaptor: Outboard motors that are smaller or older, might not have a hose adaptor but that’s okay, you can use a product called Five Oceans Universal Outboard Motor Flusher that covers the water intake hole on the engine. The same goes for stern drive motors as well.
Important: While running your engine, make sure it is in idle only, and that it is getting a steady stream of water through the water intake. Never run your engine dry without water.
Was your post meant to to ask questions or be instructional? [links]
Step 1: You can test an outboard motor without access to a boat or ocean. Simply mount it to a sturdy platform, place a big bucket underneath it and fill it with water so the propeller is fully submerged. here
I did this at TechShop Menlo Park’s automotive area!
Step 4: If your motor doesn’t start by pilling the cord it may need to be jumped similarly to jumping a car. Use a battery of at least 12 V on one end and hook up jumper cables onto the metal screw heads near the starter of the motor. more
Step 2: Clean out the gas can of old gas and oil mixture because it may be water contaminated. Add fresh gas and proper amount of two -stroke oil into the can. Different brands of oils require different amounts so read the directions carefully. Best oil on the market is Red Line brand and the ratio is 8ozs per gallon of gas.
Step 5: Pray to Sea Gods and all nautical creatures that your motor will start and run well!
If you find water in the bilge, you should remove as much of it as possible.
Due to current maritime laws, it is wise to check the water condition in the bilge before you use a pump. If the water is contaminated, you may need to get rid of it manually. here
Water in the bilge is not recommended and should be kept to a minimum level. [links]
The best way to go about this is by doing periodic checks. Modern-day boat manufactures are constantly looking for innovative ways to ensure minimal water stays in the bilge.
Leaks generally take time to be noticed, and it may be hours or even days before you notice one on your boat.
Avoid using the bilge pump to get rid of oily water. more
Step 4: If your motor doesn't start by pilling the cord it may need to be jumped similarly to jumping a car. Use a battery of at least 12 V on one end and hook up jumper cables onto the metal screw heads near the starter of the motor. [links]
Step 2: Clean out the gas can of old gas and oil mixture because it may be water contaminated. Add fresh gas and proper amount of two -stroke oil into the can. Different brands of oils require different amounts so read the directions carefully. Best oil on the market is Red Line brand and the ratio is 8ozs per gallon of gas.
Step 3: It the motor hasn't been started in a long time starting fluid will help it start. Unhook the rubber shields over the spark plugs and unscrew the spark plugs all the way out. Starting fluid/ Either is sprayed into the spark plug cavity as well as into the air filter.
Step 1: You can test an outboard motor without access to a boat or ocean. Simply mount it to a sturdy platform, place a big bucket underneath it and fill it with water so the propeller is fully submerged.
I did this at TechShop Menlo Park's automotive area! www.techshop.com
Step 5: Pray to Sea Gods and all nautical creatures that your motor will start and run well! more