See full version: How to Start a Push Lawn Mower
This article was co-authored by our trained team of editors and researchers who validated it for accuracy and comprehensiveness. wikiHow's Content Management Team carefully monitors the work from our editorial staff to ensure that each article is backed by trusted research and meets our high quality standards.
wikiHow marks an article as reader-approved once it receives enough positive feedback. In this case, 82% of readers who voted found the article helpful, earning it our reader-approved status. here
This article has been viewed 618,485 times. [links]
4. Battery (if applicable) here
Metal cans have the potential to rust so plastic is always preferred as they can keep the fuel system from encountering rust flakes.
3. Tighten Fasteners and Clean here
Some of the most common reasons a mower may not start are listed below:
1. Fuel System Preparation: The most important part of off-season or long-term storage is proper preparation of the fuel system. The last fuel fill should be treated with a fuel conditioner (a separate fuel conditioner is not necessary when using Lawn-Boy Generation II 2-Cycle Ashless Oil with added fuel stabilizer in Lawn-Boy 2-cycle engines). The mower’s fuel tank should be drained using a hand pump, available through most hardware or home center retailers, or run dry. Then, repeatedly choke (if applicable), prime and start the engine until it absolutely will not start. This will ensure the fuel system is properly prepared and lessens the potential for varnish and gum deposits forming in the fuel system resulting in starting difficulties later on. more
I promise if it was a dewalt it would have a cracked case and need a new gearbox at the very least. It'd probably need a new battery as I've kill those things by sneezing around them too hard. Honestly sick thinking how much money I've dumped into vile bile colored half garbage. Can you tell I finally converted from yellow to red about a year ago?
I've done this and broken drills doing this. In my case it was the reduction gear in my corded drill. It helps to hold it a little limp-wristed so kicks have a little room to go.
Pretty much an electric starter without a bendix setup [links]
Worked great, 10/10 would recommend. Just don't leave it on for too long as I doubt the electronics enjoy the more
This is the same method used for starting a Top Fuel Dragster. [links]
Reminds me of when recently my car had discharged its battery because my kid had left the lights on in the car. Unfortunately it turned out my jumpstarter/charger was broken. more
If you experience any problems accessing this website, please call us at 1-800-828-5500 for assistance. [links]
Attach the Troy-bilt JumpStart Bit to any cordless drill with a minimum 14.4v and easily start any Troy-Bilt jumpstart-capable string trimmer, leaf blower, cultivator or edger. Eliminates pull starting. more
Questions about your Troy-Bilt product? We're here to help.
We'll make sure you get the right part. Enjoy 90-day returns for unused parts and we won't penalize you for ordering the wrong part when you follow our return policy.* here
Phone support also available: more
Parts orders over $50 ship free.*All orders placed before 5 pm ship next day. Standard shipping averages 3 business days for delivery. Expedited shipping is available. here