[KInkade341]

There are situations where a 'smart' battery charger won't recognize a battery because the battery is deeply discharged. Some chargers have a relatively high voltage threshhold. Remember, a 12 volt battery (adjust numbers for 6 volt, etc.) is effectively discharged at 11.9 to 12 volts (fully charged is 12.72 volts). A battery can be drawn lower than this, particularly if allowed to remain totally discharged for extended periods. This is not particularly good for battery health, and may in fact destroy the battery, but that is not for this discussion.

[jacobfan]

Some of the more common 'floating chargers' for vehicle or other battery maintenance, have threshhold voltages between 8 and 11 volts. If your battery voltage is below the particular level of your charger, the charger won't acknowledge a viable battery hookup, and won't pass current. Some chargers indicate a fault mode (continuous flashing), and others just don't do anything. Some charger manufacturers don't consider a battery below their threshhold voltage as worth recharging (they're not necessarily correct). Some, particularly marine battery chargers, are designed to check for battery voltage before passing voltage/current to prevent sparks, in case the charger is plugged in without being connected to a battery, when there may be a gas buildup in the compartment. All of our chargers have very low threshholds, and will charge deeply discharged batteries.

[AgoraMutual]

There are a couple of ways to get around this, to see if your battery will recover and take some charge. It still may have to be desulfated later. First, a non-intelligent charger, like you had in your garage 25 years ago, may be used with supervision, to cram some current into the battery, which will raise battery voltage. This is another case for having a decent digital voltmeter around the shop/house. You can keep checking the battery until it has enough voltage to register on the 'smart' charger, then let the smart charger take over. If you have golf cart type 6 volt batteries, you can series a pair (positive to negative) to look like a 12 volt battery, and use a 12 volt charger as above. Second method, if you don't have a 'dumb' charger: parallel a second battery (positive to positive, negative to negative) that you know to be recognized by the charger, with the bad battery, and attach the charger. After the charger has a while to put some current back, disconnect the good battery. It may take a time or two to get the charger to stay running. What you don't want to do is leave both batteries connected for a long time, as the good battery will end up overcharged. So, both methods require supervision.

[MagicalTux]

Hope you don't need this information, but we run into this situation with customers enough, putting something together on the subject was advisable.

[user88]

more

[Foam]

[links]

[shadowdust]

Re: Minn Kota 4 Bank Charger Problems. more

[magxakic12]

Re: Minn Kota 4 Bank Charger Problems.

[geekmug]

Thanks,
I checked the polarity with the charger plugged in and that is when i noticed the difference? We are thinking maybe it got a surge and switched the polarity then some how, that is maybe what blew the fuses in the first time? I got everything hooked back up and the number 2 and 3 work but the 1 and 4 will not shut off automatically or shall I say drop down to the trickle charge like 2 and 3. I just hooked up 1 and 4 with the wires reversed to keep the polarity the right way and keep the fuses from blowing but the charger is saying check connection.. I feel that the charger is messed up but wonder if i can still use it but not leave it plugged in more than a night or so? here

[breandan81]

If you are checking voltage with the charger disconnected that is not a valid check. Connect the leads and then check voltage. I would look carefully at the charger label to see what the correct polarity really is. If two of the outputs are correct and two are opposite, I would not expect blown fuses on the two outputs which have correct polarity. I suspect incorrect connections. Start by leaving the outputs disconnected. Replace the fuses and plug in the the charger. If they blow again, the charger is toast. If not, I suspect a wiring problem. more

[cb]

If you are on a personal connection, like at home, you can run an anti-virus scan on your device to make sure it is not infected with malware.

[icaro]

Completing the CAPTCHA proves you are a human and gives you temporary access to the web property.

[Iskender]

Another way to prevent getting this page in the future is to use Privacy Pass. You may need to download version 2.0 now from the Chrome Web Store.

[Vorlon]

If you are at an office or shared network, you can ask the network administrator to run a scan across the network looking for misconfigured or infected devices. here

[david345]

If you are on a personal connection, like at home, you can run an anti-virus scan on your device to make sure it is not infected with malware.

[Pegasus-Rider]

Completing the CAPTCHA proves you are a human and gives you temporary access to the web property.

[jon_smark]

Another way to prevent getting this page in the future is to use Privacy Pass. You may need to download version 2.0 now from the Chrome Web Store.

[famoustreat]

If you are at an office or shared network, you can ask the network administrator to run a scan across the network looking for misconfigured or infected devices. here