MrMagic
17.05.2021 9:58:28
1988 Force 85hp Not rated yet
The original trim/tilt motor was a two wire unit. The replacement 2 wire unit does not work. I have an old 3 wire unit that works if I hook uo the ground … more
See full version: Force Outboard Forum
1988 Force 85hp Not rated yet
The original trim/tilt motor was a two wire unit. The replacement 2 wire unit does not work. I have an old 3 wire unit that works if I hook uo the ground … more
1988 force 125 engine cooling Not rated yet
Hello. We put in new water pump. torn engine apart to check for water blockage..water doesn't seem to go through water passages from foot to engine..new …
6. We receive dozens of posts a day and it is quite impossible to reply to more than just a few given this is a free site and I don't have enough time given I have a day job.
US Marine Force 1258V6A 1986 Not rated yet
Purchased used 1986 VIP Bass Boat with Force 125 outboard. She started right up one and ran her in neutral for a few minutes. Moved throttle FWD and … more
Re: Mercury outboard overheating
Many of you may have the same gasket failure under the powerhead.
Re: Mercury outboard overheating here
Snowfall at near freezing temperatures, roughly -2°C to +2°C is likely to have very high moisture content, and can stick to your airframe. It is unlikely to “blow off” during the takeoff roll. more
Freezing Fog (FZFG) more
*The US Government provides data for frost prediction free of charge
Cold Soak Fuel Frost [links]
Hoar frost appears as a thin , uniform deposit of ice with a fine, white, crystalline texture. It will need to be removed prior to flight, but will not reform.
Typical hoar frost found on aircraft in the morning
Yes, it can do that. A slight split in the diaphragm or an air leak means that when the pump is operated at high speed it still has sufficient capability to overcome the fault, but not at low speed.
I would check/ clean/replace the in line fuel filter and i would thoroughly clean/ flush the tank and fuel line to ensure that there is no water or debris anywhere causing the problem. [links]
I would ensure that the little clip between the float needle valve and the float is in place. Soft tip needles can stick on their seats if it is not fitted. [links]