PDA

See full version: Rx1 setting on harbor freight multimeter


danknug
02.05.2021 16:38:59

Caretaker of Portable Tube Radios


hvac001
12.05.2021 11:18:24

Caretaker of Portable Tube Radios more


fisuk
04.05.2021 15:12:31

I Should mention that this is a Simpson 260 Series 6 meter.


hannahsmith
15.05.2021 9:08:16

Well I was going to say you could use your new meter to check the battery. more


prometheus
18.05.2021 17:01:52

BTW, looks like your 260 is a Series 6. more


tadcroz81
17.06.2021 2:16:04

Re: ?? Question SIMPSON 260 multimeter ?? W/PIC


davout
01.05.2021 8:03:51

PS. It looks like the text in italics, under the big knob settings, tell you which hole the red probe should be in.


piotrp
15.05.2021 9:08:16

Here is a view of your meter. Looks like someone had the same problem. Two resistors in series. more


tadcroz81
18.05.2021 17:01:52

If you copy image then zoom in on it later you almost make out the low values. Could use a low value pot then try and zero in on the best reading as Compared to a correct meter. I think it is R-16 11 ohm. more


h4ck3rk1ng
17.06.2021 2:16:04

Both the 11.2Ω and 11Ω resistors are still available new from Simpson, or any Simpson service center.
The 1.109K is no longer available from Simpson, but has been superseded by a 1.095K resistor.
This value will still provide accuracy within the factory specified 2.5 degrees of arc.


Keefe
01.05.2021 8:03:51

Are you saying that, when you switch to R x 1 with no leads connected, the pointer swings from infinity ohms on the left to zero ohms on the right side of the scale? If it stays resting at infinity ohms with the leads shorted together, I would suspect the connections of the D-cell which is the only battery used for R x 1. If someone accidentally tried to measure voltage while in the R x 1 position, a resistor in the circuit may have opened.


johnriderjr0
07.06.2021 16:52:25

wikiHow marks an article as reader-approved once it receives enough positive feedback. In this case, 98% of readers who voted found the article helpful, earning it our reader-approved status. [links]


Shrother179
28.04.2021 20:45:35

This article was co-authored by Jesse Kuhlman. Jesse Kuhlman is a Master Electrician and the Owner of Kuhlman Electrician Services based in Massachusetts. Jesse specializes in all aspects of home/residential wiring, troubleshooting, generator installation, and WiFi thermostats. Jesse is also the author of four eBooks on home wiring including "Residential Electrical Troubleshooting" which covers basic electrical troubleshooting in residential homes.


BitcoinCyberStore.com
25.04.2021 1:00:29

There are 10 references cited in this article, which can be found at the bottom of the page.


JonCage
28.05.2021 7:35:59

This article has been viewed 393,265 times. here


marie
26.05.2021 2:40:55

A digital multimeter is a super handy tool for quickly measuring voltage, resistance, continuity, and current in many types of electrical circuits. It’s really easy to use a digital multimeter once you understand what the various symbols on the dial stand for. Soon enough, you’ll be testing all kinds of electronics with your digital multimeter! here