[nybble41]

Then hook it up like this.

[kencausey]

ok, so i have to have 2 solenoids? just want to make sure as the original pump only had 1 solenoid.

[hacim]

at this stage, I am not going to be pulling the whole drive off just to replace the switches, so no, I have been using the boat the way it is for the last 5 yrs and just want to get it back out, and this little issue is holding me up.

[TopSoil]

I am thinking the wiring may have gotten messed up, any ideas on where to find a good wire diagram to go from 2 silenoids to1?

[Dynotor]

Thanks Don,
The original pump that was in there only had 1 solenoid, maybe that is because there is no 3 button switch at the helm? all it is, is a toggle up and toggle down switch, and no tilt or trim in the handle either. more

[alanpayne143]

Ok, you have a single toggle switch for up and down without a trim limit switch or a gauge is that correct? more

[grrrl]

Re: Alpha 1 Gen 2 trim limit solenoid test more

[dorianm421]

I thought the same thing after writting my last post. [links]

[anon8373]

Re: Alpha 1 Gen 2 trim limit solenoid test [links]

[ihateregistering]

Re: Alpha 1 Gen 2 trim limit solenoid test

[emeacham]

12 Volt 3-Wire Trim Pump Motor

[knightmb]

This is a replacement steel reservoir can. This is used on our 137-8232 & 137-8233 trim pumps. It is 3.70" diameter at the top. 3.60" diameter at the bottom. 4.87" tall.

[marycaouette]

We carry a selection of new trim pumps for your outdrives, trim tabs and hatch rams. Floor mount trim pump for the stock stern drive package and high performance mount for the offshore racer. We also stock new replacement reservoir tanks and electric trim motors for replacement. These are what the factory uses, just not the factory price.

[dooglus]

24 Volt 3-Wire Trim Pump Motor more

[SlipperySlope]

Rebuilding or Repairing a sterndrive can be a difficult endeavor, however, we have numerous customers who successfully complete all kinds of repairs at a great savings. here

[sahars]

Sterndrives.com can help you select the parts you need.
We have years of experience in accurate parts selection and options and we will be able to narrow down your request.
Simply send us an email from below:

[happymoon]

Mercruiser produced several models of sterndrives before the Alpha One was introduced.
These include the common "R" sterndrive, 888 sterndrive, 898 sterndrive, I and MR as well as others. more

[costner1367]

Most customers start by buying a Service Manual.
Manuals are used on a regular basis even by our most experienced Mercruiser Techs. The manuals show all the procedures and they have a list of the special tools required to complete the job if required. It's a great idea to have a manual even if you don't perform the repair yourself because you can get a good idea as to what your tech should be doing. [links]

[adamjkok]

Almost every pre-alpha part can be ordered from the Alpha One Parts section.
Pay attention to R or MR specification in the Lookup Index. here