[Mrs Linda Kent]

Remove trim motor and check condition of drive coupling. If coupling is damaged, replace it.

[cookie]

Starting with the tilt cylinder fully retracted, run the unit UP.

[knightmb]

Cycle the unit down and up several times to purge air. With all rods fully extended, run the unit down momentarily to reduce pressure. Check fluid level again, and add fluid if necessary. Remember that all rods must be completely extended to check fluid level

[AstroBloom18x]

Power Trim/Tilt Service Kit, P/N 434524, allows testing of trim/tilt operation and component condition. here

[chupacabra]

If you are on a personal connection, like at home, you can run an anti-virus scan on your device to make sure it is not infected with malware.

[akaz456]

Another way to prevent getting this page in the future is to use Privacy Pass. You may need to download version 2.0 now from the Chrome Web Store.

[bshimul93]

If you are at an office or shared network, you can ask the network administrator to run a scan across the network looking for misconfigured or infected devices.

[sahars]

Completing the CAPTCHA proves you are a human and gives you temporary access to the web property. here

[fleming.fletcheer]

Warranty All of our units come with a Full 2 Year Warranty and we save all your information in our system indefinitely. We stand behind our work 100% that way you have peace of mind and someone you can count on. We have very few issues because of the process we have developed to ensure all units are properly rebuilt and leak and pressure tested before shipment. here

[mshare1]

Shipping Address Five Star Marine At 6902 Industrial Ave, Port Richey, FL 34668 here

[carp]

Option 2 Find a used unit and gamble on it working properly, many of these used units floating around on eBay and at shops are pulled off junk motors and they tend to be only good as cores with no real life left in them and you would be spending money on something that won’t give you any value for your money.

[krypton1]

Painting & Corrosion Protection We offer a Sand Blasting and Epoxy coating service where we blast your unit to bare metal and built it back up with an Industrial Grade Epoxy Primer. This process is mostly for Boat Owners who keep the boat in the water for extended periods of time and are experiencing corrosion problems.This special coating helps fully insulate the unit from any contact with the water then top coated to match your factory colors. The cost of this process is a flat rate of $100 and should seriously be considered if you keep your boat in the water.

[mnem0sys]

Option 3 Send your unit to Five Star Marine and have it rebuilt by the professionals. We offer a Full 2 Year Warranty on all of our rebuilds. We do the highest quality work in this field hands down. Every unit goes a through a Full Remanufacturing Process that will outlast a New Unit. Using only the highest quality Seals, Fluids & Sealants available.