PDA

See full version: How to Troubleshoot the Trim Switch on a Bass Tracker Boat


geebus
06.05.2021 23:55:41

Remove the screws in the throttle handle and remove the cover to access the trim switch. Note the position of wires before removing them from switch terminals. The middle wire is red and furnishes 12 volts to the switch at all times. The blue wire applies 12 volts to raise the engine. The green wire applies 12 volts to lower the engine. When the switch is pressed, the respective contact inside touches the red contact to receive 12 volts to function.


AT-LOW
19.06.2021 8:50:27

Set the multimeter to the continuity check position. Troubleshoot the up position of the switch by touching the red lead to the terminal to which the red wire was connected. Touch the black lead to the terminal to which the blue wire was connected. Press the button labeled up and listen for the tone from the multimeter. If you hear a tone, the up position of the trim switch is good. If you don not hear a tone, it is bad.


jasonlandmark66
20.06.2021 20:15:41

Remove the wires from the switch terminals with needle-nose pliers. This will isolate the switch from the circuit. Examine the switch terminals for corrosion, which could affect your readings. Remove any corrosion found using sandpaper.


singpolyma
20.04.2021 8:31:14

The power trim switch on a boat raises and lowers the engine. It positions the boats engine for optimum performance while underway. The power trim switch also raises the engine when transporting the boat so the prop clears the ground. The power trim switch usually is located on the throttle but may be located on the engine and/or the bow of the boat. Each of these switches is wired the same. These instructions refer to the switch at the throttle, but can be used on any switch.


sc8nt4u
01.06.2021 8:54:16

After I completely unhooked the switch, I tried putting the terminals back on the battery. When I do this, the motor starts to run and the motor tries to go down. So it is still on , after unhooking what I thought was a bad switch. here


Anon136
27.04.2021 20:17:22

You assumed right Mike. Everything I own is old, including me.


KInkade341
08.05.2021 18:22:47

Where in the hades, can I get these little bitty fuses?


mico
05.05.2021 12:43:15

I think that may tell me if it is the motor or a short.


telyni
01.06.2021 8:54:16

If you are at an office or shared network, you can ask the network administrator to run a scan across the network looking for misconfigured or infected devices. here


buybacklinks.seos
27.04.2021 20:17:22

Completing the CAPTCHA proves you are a human and gives you temporary access to the web property.


Giovanny
08.05.2021 18:22:47

If you are on a personal connection, like at home, you can run an anti-virus scan on your device to make sure it is not infected with malware.


Bitquux
05.05.2021 12:43:15

Another way to prevent getting this page in the future is to use Privacy Pass. You may need to download version 2.0 now from the Chrome Web Store.


Renton777
20.06.2021 20:28:26

Cloudflare Ray ID: 68770d42ddbe16ab • Your IP : 46.32.66.208 • Performance & security by Cloudflare


stakhanov
01.06.2021 8:54:16

If you are at an office or shared network, you can ask the network administrator to run a scan across the network looking for misconfigured or infected devices. here


harding
27.04.2021 20:17:22

Completing the CAPTCHA proves you are a human and gives you temporary access to the web property.


checker
08.05.2021 18:22:47

If you are on a personal connection, like at home, you can run an anti-virus scan on your device to make sure it is not infected with malware.


TryBitCoin
05.05.2021 12:43:15

Another way to prevent getting this page in the future is to use Privacy Pass. You may need to download version 2.0 now from the Chrome Web Store.


Jacob Boersma
20.06.2021 20:28:26

Cloudflare Ray ID: 68770d68ca63d6b5 • Your IP : 46.32.66.208 • Performance & security by Cloudflare