suckless
09.06.2021 20:08:53
Another way to prevent getting this page in the future is to use Privacy Pass. You may need to download version 2.0 now from the Chrome Web Store. [links]
See full version: One more step
Another way to prevent getting this page in the future is to use Privacy Pass. You may need to download version 2.0 now from the Chrome Web Store. [links]
If you are on a personal connection, like at home, you can run an anti-virus scan on your device to make sure it is not infected with malware. more
If you are at an office or shared network, you can ask the network administrator to run a scan across the network looking for misconfigured or infected devices.
Completing the CAPTCHA proves you are a human and gives you temporary access to the web property. here
Cloudflare Ray ID: 687cc3fb2b641604 • Your IP : 46.32.66.208 • Performance & security by Cloudflare more
Another way to prevent getting this page in the future is to use Privacy Pass. You may need to download version 2.0 now from the Chrome Web Store.
If you are on a personal connection, like at home, you can run an anti-virus scan on your device to make sure it is not infected with malware.
If you are at an office or shared network, you can ask the network administrator to run a scan across the network looking for misconfigured or infected devices.
Completing the CAPTCHA proves you are a human and gives you temporary access to the web property.
Cloudflare Ray ID: 687cc3fb997f164b • Your IP : 46.32.66.208 • Performance & security by Cloudflare here
Re: Rectifier or Stator sends signal to Tachometer more
Not necessarily. A shorted rectifier will interfere with the stator's operation which could affect the tachometer. Before even thinking about replacing the stator, test the rectifier as follows:
Make sure your pulse on the Tach is set correctly I believe it is 6 for your engine. more
Stator to rectifier back to stator then to tach? more
In the image, there is a single gray wire coming off of the unrectified side of the rectifier. That gray wire runs into the wiring harness, up to the dash of the captains chair, and into a 12V tachometer. I've been told that it is measuring AC cycles in order to extrapolate engine speed but I'm unsure of the method by which you use to measure cycles with only one wire? more
Voltage is, by definition, the potential between two different points within a circuit, so how does this work? Is it using the Hall effect?
[links]