See full version: How to Mount a Trolling Motor on a Boat: The Complete Guide
Once you have determined the right position for your mount, you need to drill two holes in your boat’s bow. Sometimes, two people are required for this job. Be smart and don’t try to do it on your own if you don’t have much experience. [links]
After you have put the motor together, the second step is to attach the shaft. Once in place, you can install the head assembly to the mount. more
Also, to ensure safety, make sure you are using a position that allows for proper flushing. Usually, this is necessary for the boat and motor to work correctly and efficiently. here
Most motors will clearly show the mounting holes. more
If there is no overhang on the side of your boat, be sure to watch out for docks. If you aren’t careful, you may end up hitting it, and all the time you spent to install the motorhead properly will be for nothing. here
Maneuvering an aluminum boat is exhausting, especially if you are in the water for a long time. For those who hate paddling, a trolling motor is a must-have. It helps in conserving energy and enjoying your time in the water. How to mount a trolling motor on an aluminum boat?
In this section, I will break down the steps, depending on the specific part of the boat where you will install the motor.
The size is equally important. It dictates the thrust that the motor will generate. This should match the length of the boat where you will attach the motor. [links]
Re: electric trollingmotor recommendations for 14 ft jon boat
Re: electric trollingmotor recommendations for 14 ft jon boat here
Re: electric trollingmotor recommendations for 14 ft jon boat
Maybe this will help. Depends on the boat whether you would want to mount a transom mount or not. On a Johnboat, a transom mount would work fine. 30 LBS will do fine, unless you fish in open water with alot of wind.<br /><br /> web page
Re: electric trollingmotor recommendations for 14 ft jon boat here
I would imagine the windings in that armature got a little on the warmish side. <br />Pretty bad when you have to consider Rake and cup on your trolling motor prop.
Then I'd make a pattern out of a piece of cardboard for a piece that will lay on top of the rails but be just inside the edges. no overhang. Take the cleat off.
Screw it down into the top of the rails with these self tapping screws.
When I was using wood I had a guy bend a sturdy piece of angle into a Z shape and then made cuts so it would bend and then screwed it down. more