Re: 1990 Johnson 25 HP - Lower unit removal
See full version: 1990 Johnson 25 HP - Lower unit removal
Re: 1990 Johnson 25 HP - Lower unit removal
Re: 1990 Johnson 25 HP - Lower unit removal [links]
(Look carefully at your picture, there are clearly two pieces that come apart)
Thanks for your feedback! I had already removed the nut, and the 4 bolts. Maybe my eyes are going bad, but by just looking at the actual hardware, it doesn't look like there are two separate halfs to the retainer connecting the upper and lower shift rods - The picture does make it look more possible, but the hexagonal shape of the upper/lower nut are sooo matched up, I just didn't believe it. I will try again tonight.
If you pulled the screw from the skeg that is the shift dog pivot you gotta take it back apart, turn it upside-down and re-align the hole while playing with the shift rod.:redface: here
The ends of the shift rod are round, and the bolt goes thru the bottom of the round part to hold it in the connector. more
Sounds lke you didn't have it seated in the clamp and it pulled out. more
Re: Evinrude 25hp Easter morning screw up! Help! [links]
remove inspection plate on lower unit, remove one bolt from the shift rod connector. make sure that both ends of the shift for are seated firmly in the connector, reolace the bolt and tighten.
Brand new, genuine Johnson/Evinrude/Omc/Brp Outboard Lower/Upper Shift Rod Keeper. This is a factory original equipment item, not aftermarket. more
table.tableizer-table
This product may contain chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.