cbrendanjarvisi
20.04.2021 11:39:31
These installation instructions contain information that can help prevent personal injury and damage to equipment. Understand the following symbols before proceeding:
See full version: Electric Start Kit P/N 174784 and 175178
These installation instructions contain information that can help prevent personal injury and damage to equipment. Understand the following symbols before proceeding:
TO THE OWNER
[30]
Place shift handle in NEUTRAL. Adjust the switch up or down so the switch plunger is 1/16 in. (1,6 mm) from "bottoming". This can be done by inserting a 1/16 in. (1,6 mm) drill bit between the shoulder on the switch plunger and the bottom of the switch body, and moving the switch down until the cable lever pushes the plunger and drill bit up against the switch body. Tighten the switch screws carefully.
Another way to prevent getting this page in the future is to use Privacy Pass. You may need to download version 2.0 now from the Chrome Web Store.
If you are on a personal connection, like at home, you can run an anti-virus scan on your device to make sure it is not infected with malware. more
Completing the CAPTCHA proves you are a human and gives you temporary access to the web property. more
If you are at an office or shared network, you can ask the network administrator to run a scan across the network looking for misconfigured or infected devices. here
Cloudflare Ray ID: 687f0fe15f6d3a9b • Your IP : 46.32.66.208 • Performance & security by Cloudflare more
CAUTION!! The motor will not shut off with the key during this test. You will have to choke it to shut it down, and it could start from your turning the flywheel by hand. I do not recommend you run the motor other than testing with this wire disconnected!
Rapair/CDI Electronics has grown to be THE source for quality electronic ignition parts for all makes of US outboard motors. Now supplying some of the OEM manufacturers with selected components. Some components of the outboard electrical system are not available from CDI, in this case I have listed the FACTORY part in its place in the shopping cart. more
FOR 4-stroke Ignition, please LOOK HERE more
Magnets come off your 90 ° 35-amp flywheel? Here's a fix! here
Meet the MasterTech!
(click picture) more
TROUBLESHOOTING TIP: All electric start motors have a "stop" or "kill" circuit that carries all the primary power thru the wiring harness and keyswitch as well as the emergency stop switch on newer models. Shorting of this high voltage circuit on magneto energized CD systems many times is the source of misses, intermittent spark, weak spark and NO spark. An easy test (and the FIRST test I run) is to disconnect the stop circuit at the powerpack plug-in or screw terminal. This wire will be black with a yellow stripe on all modern motors. This will isolate the harness, etc. and allow you to see if the motor's system is functional.
A Sampling of
CD Ignition Parts
Meet the MasterTech!
(click picture)
Engine wiring harnesses are also available for most motors. Please CONTACT US for price & availability. here