inkubus
11.05.2021 9:06:30
If you are on a personal connection, like at home, you can run an anti-virus scan on your device to make sure it is not infected with malware.
See full version: One more step
If you are on a personal connection, like at home, you can run an anti-virus scan on your device to make sure it is not infected with malware.
Another way to prevent getting this page in the future is to use Privacy Pass. You may need to download version 2.0 now from the Chrome Web Store.
Completing the CAPTCHA proves you are a human and gives you temporary access to the web property. more
If you are at an office or shared network, you can ask the network administrator to run a scan across the network looking for misconfigured or infected devices. [links]
My goal is to get my 14' Livingston to do a consistent 25 mph top speed with two guys on board. By tweaking my outboard mounting height/angle and going to a slightly smaller prop size, I've gotten my current top speed up to 23 mph from 19 mph. There are still a few minor tweaks I can do, so hopefully I'll get there. My outboard is a 30hp Tohatsu 2stroke from the mid 80's. It's ugly looking, but super reliable and lightweight at about 110lbs.
My previous Livingston was 12' with a late 90's Honda 15hp 4stroke. My top speed on that boat with two guys on board was about 19 mph.
Some recommendations:
Raising your transom mount a few inches above factory standard will generally decrease outboard drag and cavitation without any loss of power.
If you are not achieving close to your engine's maximum recommended rpm's at full throttle, consider trying a smaller prop. Likewise, if your rpm's are too high, then the reverse can also be true.
Install a drain plug in the back of your center stabilization hull. Both of my Livingstons had a couple of gallons of water that accumulated in there over the years. Not only is this a safety issue, it added a lot of extra weight that decreased performance. more
[links]
FACTORY CPO: Refers to a used engine that has been inspected and certified at a Mercury Marine facility and receives a one year Parts & Accessories warranty upon resale. On Factory CPO products, one or two year contracts are available beyond the one year Parts & Accessories warranty for total coverage of up to three years.
What is a MerCathode and what does it do? here
‘Non-declining’ means that the warranty coverage is the same on the last day of your warranty as it is on the first. The coverage doesn’t decline based on the age of your engine, or the number of hours you’ve put on it.
MAP is factory-backed and covers the major assembly if there is a failure caused by a defect in material or workmanship. Parts and labor are covered on approved claims.
Be sure the following information is included on your bill of sale:
• Date the engine was purchased
• Engine serial number
• Your name and address
• Your telephone number
Do I need to put antifreeze into the raw-water/seawater section of the cooling system after draining? [links]
Another way to prevent getting this page in the future is to use Privacy Pass. You may need to download version 2.0 now from the Chrome Web Store.
If you are on a personal connection, like at home, you can run an anti-virus scan on your device to make sure it is not infected with malware. here
Completing the CAPTCHA proves you are a human and gives you temporary access to the web property.
If you are at an office or shared network, you can ask the network administrator to run a scan across the network looking for misconfigured or infected devices.
Cloudflare Ray ID: 687dc6190a0375af • Your IP : 46.32.66.208 • Performance & security by Cloudflare
[links]