[jcw9]

If you have purchased a brand new car stereo and wish to install the stereo on your own, then you will need to know where the red, yellow, and black stereo wire colors go when attaching them to the stereo. The stereo wire colors include blue, white, purple, grey and orange. The red wire is for the 12 volt ignition, which can be attached to the stereo. The yellow wire is the 12 volt battery wire, which should also be attached to the stereo for power. The final wire, the black wire, is the ground wire. This wire, once attached to the stereo, will help ground it. [links]

[tamara]

[BlackEye]

[nephia]

[rydiamage]

[links]

[sc8nt4u]

[dooglus]

RCA cables (line-level connections) are the preferred way to connect a signal to your amp if you have that option. RCA jacks on the rear of a Pioneer head unit. This is the ideal way to connect your amplifier's signal inputs, if available. For a 4 channel amplifier, you'll need 2 stereo RCA cables to do so.

[falkenberg]

Can you install an amp without RCA jacks?

[directair]

Secondly, do you need RCA cables on an amp? Car amplifiers don't come with any wiring included. You must supply the amp's power and ground wiring, an inline fuse, a remote turn-on wire, RCA cables, and speaker wires.

[PLATO]

This article has been viewed 265,601 times. [links]

[efu321]

Installing a new car stereo is a great way to breathe new life into your old daily driver. Adding a CD player or MP3 ready stereo to your car can give you the opportunity to listen to new music as well as improving the overall sound quality of your car’s sound system. Doing the installation yourself can be a bit daunting, so it’s important to approach it with patience. Because every car and every model stereo are a bit different, you might want to do some research on your specific car before getting started. [links]

[Kline]

This article was co-authored by our trained team of editors and researchers who validated it for accuracy and comprehensiveness. wikiHow's Content Management Team carefully monitors the work from our editorial staff to ensure that each article is backed by trusted research and meets our high quality standards.

[astrid01]

There are 8 references cited in this article, which can be found at the bottom of the page.

[williamsanderson71]

To wire a car stereo, start by disconnecting your car battery to avoid electrocuting yourself. Then, match the colored wires of your radio and your car and twist the wires together. If your car requires an output converter, connect this as well so your radio will work with your car. Once you’ve connected your radio wires, secure them with solder or heat-shrink wrap. If you don’t have either of those, you can wrap the wires with electrical tape. After you’ve secured your radio wires, connect your car battery and test the radio. If it works fine, tuck all the wiring into your dashboard and slide the stereo back into place. You may also need to screw the stereo into place if it doesn’t use spring clips. For more tips, including how to remove your old car stereo before wiring in a new one, read on!

[rainerfox]

If you have purchased a brand new car stereo and wish to install the stereo on your own, then you will need to know where the red, yellow, and black stereo wire colors go when attaching them to the stereo. The stereo wire colors include blue, white, purple, grey and orange. The red wire is for the 12 volt ignition, which can be attached to the stereo. The yellow wire is the 12 volt battery wire, which should also be attached to the stereo for power. The final wire, the black wire, is the ground wire. This wire, once attached to the stereo, will help ground it. [links]

[Zodar]

[links]

[daemox]

[wlisabethfitzgeraldv]

[skinnyp83]