narisseproe
31.05.2021 8:53:32
If you are at an office or shared network, you can ask the network administrator to run a scan across the network looking for misconfigured or infected devices. here
See full version: One more step
If you are at an office or shared network, you can ask the network administrator to run a scan across the network looking for misconfigured or infected devices. here
If you are on a personal connection, like at home, you can run an anti-virus scan on your device to make sure it is not infected with malware. here
Another way to prevent getting this page in the future is to use Privacy Pass. You may need to download version 2.0 now from the Chrome Web Store. [links]
Completing the CAPTCHA proves you are a human and gives you temporary access to the web property.
Cloudflare Ray ID: 687bb8f5fb88fe34 • Your IP : 46.32.66.208 • Performance & security by Cloudflare
If you are useing Tubes instead of a pump. Just snip the top of the tube open. Force the tip into the drain hole, and squeeze it in. Yes it is a little messy. Just force the lube in, till it comes out the top vent. Put the top vent screw back in. Then put the bottom drain plug back in as soon as possible. A little oil will escape while you fumble with the drain plug. no problem [links]
The drain screw is is in the bottom of the lower unit towards the front. The vent screw is just above the first fin on the side of the lower unit.
Sometimes the Vent and Drain screws are very tight. Use a LARGE screw driver and lean into it while applying twist, to get them out. Wipe the screws clean with the rag, some have little magnets on them. The screws will have a little gasket or 'o' ring seal, just reuse them. [links]
keep clear of the flywheel
while engine is running more
Now the Top part of the Engine is ready for spring time. here
2. Remove air box cover. Pull the boat up on the trailer at the launch ramp. With the engine still in the water (for cooling). Shut off Engine and remove the Engine Hood. Then remove the air box cover on the front of the engine, exsposing the carburetors. Do not loose the screws or the plastic cover in the lake.
If you have a 4 stroke outboard, you should change your oil and filter.