KInkade341
08.05.2021 14:25:38
If you are on a personal connection, like at home, you can run an anti-virus scan on your device to make sure it is not infected with malware.
See full version: One more step
If you are on a personal connection, like at home, you can run an anti-virus scan on your device to make sure it is not infected with malware.
Another way to prevent getting this page in the future is to use Privacy Pass. You may need to download version 2.0 now from the Chrome Web Store. [links]
Completing the CAPTCHA proves you are a human and gives you temporary access to the web property. more
If you are at an office or shared network, you can ask the network administrator to run a scan across the network looking for misconfigured or infected devices.
I bought carb cleaner spray and tried to clean carburetor that way - so the short version of my question is: is it good enough based on how it's running in the second video below (around 9 minute mark), or should I disassemble and attempt to clean the carburetor manually?
I bought carb cleaner spray and tried to clean carburetor that way - see video below, it was difficult not to let the engine stall and I could not do it continuously like instruction said, or the engine would stall for sure. I did it several times, using about half or more of the can. Look towards the end of the video (around 9 minute mark) - I still see some uneven shuddering but I let it run on lowest throttle with forward gear engaged for 10 minutes and it didn't stall. So it looks a it's better now, but I'm still not 100% sure if it's completely fine. Still vibrates kind of unevenly, but didn't stall at least.
Please look at the video: you can see uneven detonation - it is shuddering neurotically, then after I put it to forward gear it becomes unstable and eventually stalls. This is before I sprayed any carb cleaner:
Last season I had a problem with my 1989 Yamaha 9.9 4-stroke I bought with my Mac 26D 3 years ago. It became very unstable at idle and low throttle - sputtering and stalling unless I give it a little gas. Sometimes after starting and running for a while, then sailing, it would not want to start again, requiring a few tries and extra throttle until it started. It's used only a few hours in a season. It was fully serviced before I bought it and insides look like new for the most part. I replaced the impeller when I bought it. Yesterday when I got it out of my basement where I stored it for the winter, I changed oil in upper and lower units, changed spark plugs, that didn't help. more
My Yamaha Outboard 175 hp motor recently started to sputter and then die when I am in idle. I suspect that the problem may have to do with the fact that the boat has been out of commission for a few weeks and wasn't used due to a broken steering cable. (That's another story). more
I also noticed that when I washed the motor out at the landing the motor was able to idle but it sounded "richer" or "heavier" than normal. [links]
Any help or advice given is greatly appreciated by me. Thank you in advance.
Does anyone know what the cause and possible cure is for this problem. The boat runs fine at higher rpm but when it is in idle, the motor wheezes or coughs and then dies. It will start back up but then the problem occurs again. [links]
Thanks
I will look at these item again. This one has me baffeled. more
Easy to test..remove the prime start from the carb and apply 12 v to it and the needle should extend and let it cool and needle should retract. [links]
I have a 9.9 EXHY. I use the motor for walleye fishing *****ing at 1.0 to 1.7 MPH. The motor ran perfect until this year. After a few hours of *****ing the motor just stalls. Will not start unless I use the priming bulb. After it starts it will run for a few minutes then quit. After a few stalling cycles the motor will idle high and it is very hard to get it to idle at a normal speed and then stalls out after a few minutes.
I suppose if this is stuck in the retracted position allowing extra fuel through. it would be like running the engine with the choke on. [links]